Assembling your AirgardenUpdated 2 years ago

Check out this video, or written instructions below, for instructions on how to assemble your Airgarden.

1) Unbox your Airgarden and lay pieces on the floor

2) Install the reservoir bung

• Take the bung insert and screw it into the corresponding hole at the bottom of the base

3) Turn base upside down and install wheels

• Take four wheels and spanner from the large clear bag included your tote bag
• Use spanner and screw in the two lockable wheels on the SAME side as each other, turning the spanner in a CLOCKWISE direction
• Screw in the remaining two non-lockable wheels
• Ensure you screw all wheels in until HAND TIGHT

4) Connect hose and place pump in base reservoir

• Turn over the base reservoir and ensure both wheels are locked into place 
• Take clear hose & 2 x hose connectors from the clear bag included in your Airgarden tote bag
• Fit hose connectors to each end of the clear hose 
• Take ½ hose adapter from clear bag and screw into top of pump
• Check dial on front of pump is pointing to the top left for max flow 
• Connect clear hose to pump
• Place pump in the centre of the base reservoir with dial facing towards the outside
• Press firmly to secure suction feet, place cord in cord channel

5) Feed hose through reservoir lid and assemble body sections

• Feed clear hose through the centre hole in reservoir lid. Place reservoir lid firmly on the top of base reservoir
• Set aside showercap lid and base
• Take first body base section and feed clear hose through centre 
• Line up the notch on the side of the body base with the large opening in the centre of the reservoir lid 
• Drop body base into position and turn clockwise to lock in 
• Take first body top section and feed clear hose through centre
• Line up all 5 pins to corresponding holes in body base section and snap down firmly into place

6) Assemble remaining body sections

• Take second body base, place clear hose through centre hole (as per previous step)
• Line up notch on side of body base section with first dot on body top - to the right of the “lock” symbol
• Turn clockwise (to the left) until notch is above the second dot to lock in place
• Ensure with each level, you feed the clear hose through the centre of body base and body top, and rest on the edge as you go
• Repeat this process until all four remaining body base sections and tops have been installed

7) Thread hose adaptor through showercap base and lock into place

• Take second body base, place clear hose through centre hole (as per previous step)
• Line up notch on side of body base section with first dot on body top - to the right of the “lock” symbol
• Turn clockwise (to the left) until notch is above the second dot to lock in place
• Ensure with each level, you feed the clear hose through the centre of body base and body top, and rest on the edge as you go
• Repeat this process until all four remaining body base sections and tops have been installed